Mighty Drive

FEATURES:

Cost effective modular design
Uses compact UnoDrives to allow expansion from 1 to 4 axes
Individually selectable full-step or half-step operation on each axis
Automatic overtemperature protection
Solid State Relay (12 AMP) for spindle motor or general purpose AC control.

The new MightyDrive is a compact, modular stepper motor driver subsystem. Available in 1, 2, 3, or 4 axis models, the MightyDrive attaches directly to the OptiStep or the MN400E controller via a standard 25 pin D type cable. The current per phase is factory set at 1.2 Amps but can be adjusted via a resistor. The built-in 40 volt high efficiency power supply delivers 1.2 Amps per phase to up to 4 stepper motors.

SPECIFICATIONS:

Drive circuit Bipolar constant current

Chopping rate 20 KHz nominal

Operating voltage 40 VDC

Output Current 1.2 Amps per phase continuous

Stepping Mode Half / Full step selectable

Current cutback Half current. after 1/2 second of idle

Step inputs 4 TTL compat. pos. edge trig.

Direction inputs 4 TTL compatible

Limit switch inputs 8 TTL compatible

Shield switch input 1 TTL compatible

Control output 1 AC 12Aamp non inductive 5 Amp inductive max.

Motor control outputs 4 lines per axis

Working temp. range 32 F ~ 158 F (0 C ~ 70 C)

Warranty 5 years parts and labor

Drive circuit	Bipolar constant current
Chopping rate	20 KHz nominal
Operating voltage	40 VDC
Output Current	1.2 Amps per phase continuous
Stepping Mode	Half / Full step selectable
Current cutback	Half current. after 1/2 second of idle
Step inputs	4 TTL compat. pos. edge trig.
Direction inputs	4 TTL compatible
Limit switch inputs	8 TTL compatible
Shield switch input	1 TTL compatible
Control output	1 AC 12Aamp non inductive 5 Amp inductive max.
Motor control outputs	4 lines per axis
Working temp. range	32 F ~ 158 F (0 C ~ 70 C)
Warranty	5 years parts and labor