QuickPhase™
Stepper Motor Indexer/Driver
Full/Half Step, 16V, 1.0A

FEATURES: Includes motion controller, translators, and power drivers on one card Provides control for up to 3 axes per board Has 6 inputs for end-of-travel limit switches Automatic overtemperature protection Does not require a device driver Easy to use software Programmable acceleration / deceleration Uses bipolar chopper circuit to provide the highest performance

The QuickPhase-PC is a complete stepper motor indexer and driver for up to 3 axes. Its space saving design features on board 1 AMP bipolar constant current drivers. The QuickPhase-PC inserts directly into any IBM-PC or compatible and requires no external enclosure. Use an external power supply or use one of your computer's disk drive power connectors. Suitable for low to medium speed applications, the QuickPhase-PC is ideal for CAD/CAM modeling, robotic and laboratory research applications.

SPECIFICATIONS:

Drive circuit	Bipolar constant current chopper
Chopping rate	20 KHz nominal
Operating Voltage range	10 ~ 16 VDC
Output current	1.0 Amp per phase(factory setting)
Limit Switch Input signals	6 TTL compatible active low
Auxiliary Output control signals	2 TTL compatible active low
Motor control outputs	4 current mode chopper lines per axis
Current capability	0.9 Amp per phase continuous
Working temperature range	32° F ~ 158° F (0° C ~ 70° C)
Warranty	5 years parts and labor

SOFTWARE:

Several software options are available. Any one software package will operate on its own. (i.e. you do not need one package to run another). The software you choose depends on your application. The software options are as follows: 1)MillMaster Pro^tm or 2)TurnMaster Pro^tm.

REQUIREMENTS:

• 8 or 16 bit IBM PC / AT expansion slot
• DC power supply to power stepper motors

BLOCK DIAGRAM

 

MECHANICAL OUTLINE

 

TYPICAL APPLICATION USING BREAKOUT 25-QP

Back to Legacy Hardware

Back to Home Page